The LFO-11 is an advanced low frequency oscillator.


CONTROLS

WAVE

The wave button changes the waveform to sine, triangle, square, or sawtooth.

RATE

The rate knob changes the frequency of the oscillator.

SYNC

The sync button syncronizes the oscillator to either hz or tempo.

CV AMT

The control voltage amount knob applies the CV socket input to the frequency.


SOCKETS

TRIG

Retrigger input.

CV

Control voltage input for frequency modulation.

OUT +

Unipolar output.

OUT +/-

Bipolar output.

TYPE

Modulation

WAVEFORMS

Sine, Triangle, square, sawtooth

FREQUENCY RANGE

50hz to 10 seconds (hz) or 1/64th note to 1 bar (tempo)

OUTPUT

+/- 1 volt (bipolar) or 0 - 1 volt (unipolar)


MORE INFORMATION

The rate of the LFO can be modulated for some extreme effects.

The LFO phase can be retriggered as well, allowing you to sync the LFO with signals such as a gate, for a consistent LFO response every time you play a note.

If the LFO was to be used as an audio source, you would find that the waveforms are not band limited and may contain audible aliasing harmonics.

TIP

Low frequency oscillators are most commonly used to modulate oscillator or filter frequency, but can be used to control any parameter with a CV input.

The unipolar output is useful for filters and keeping oscillator pitch moving in one direction compared to the root note.